Güvən Servis

Dishwasher Leaking Water — Causes and What to Do

October 27, 2026Güvən Servis377

A puddle on the kitchen floor, damp under the cabinets, maybe even a call from the neighbours below. A dishwasher leaking water shouldn't be ignored: flooring swells, furniture is damaged and water near electrics is dangerous.

Safety first

  1. Unplug the machine.
  2. Turn off the water tap.
  3. Mop up the water.
  4. Warn downstairs neighbours if needed.

Where is it coming from?

  • Under the door — seal, foam, loading or an unlevel machine.
  • Underneath, centre — pumps, seals, internal hoses.
  • At the back — inlet or drain hose connections.

Main causes

1. Worn or dirty door seal

Clean it and look for cracks; replace if worn.

2. Wrong detergent — too much foam

Hand dish soap foams heavily and escapes through the seal. Use dishwasher detergent only.

3. Machine not level

Water collects at the door. Adjust the feet with a spirit level.

4. Hoses and connections

Loose nuts, worn washers or cracked hoses.

5. Water in the Aquastop tray

Internal leaks drain into the base tray, the float rises and E15 appears — a leak exists even if the floor is dry. See dishwasher not filling.

6. Pump shaft seal

Wears out after 5–7 years and drips into the base.

7. Internal hoses and clamps

8. Salt reservoir cap or cracked spray arm

Home checks

  • Clean and inspect the door seal.
  • Check the detergent; run empty rinses if foamy.
  • Level the machine.
  • Inspect rear hose connections during a cycle.
  • Close the salt cap firmly.

When to call a technician

If water comes from underneath, E15 appears, the seal is fine and there's no foam, or water has reached electrics, call our dishwasher repair service. We find internal leaks and replace seals, pumps and hoses on Siemens, Beko and other brands. Error code guides: Beko, Siemens.

How to prevent leaks

  • Inspect hoses yearly. Replace them if cracked, bulging or discoloured; a standard inlet hose lasts about 5 years.
  • Keep the door seal clean — wipe it weekly.
  • Use only dishwasher detergents.
  • Install the machine level and make sure the cabinet panel doesn't stop the door closing.
  • On older models without Aquastop, fit a leak sensor or safety valve.
  • When away for a long time, turn off the water tap.

What our technician checks

The technician runs the machine to see at which stage it leaks, then removes the side and bottom panels, dries the base tray and finds the leak directly — pump seal, internal hoses, clamps, spray arm joints or salt reservoir. Limescale or rust traces often reveal the spot. The faulty part is replaced with an original, the machine is run on a test cycle, and the tray is confirmed dry before the job is handed over with a warranty document.

A small but regular leak under an integrated machine can go unnoticed for months until the laminate swells or mould appears. A musty smell under the kitchen units is a reason to check, even without a puddle. In an apartment block, flooding the neighbours costs far more than replacing a hose or seal.

Common mistakes

  • Managing the leak with towels. Water soaks into cabinets and flooring.
  • Tilting the machine to empty the tray. It clears E15 temporarily, but the leak remains.
  • Patching a hose with tape or silicone. It fails under pressure — replace the hose.

Frequently asked questions

I used hand dish soap — what now?

Stop the cycle, remove the foam, add a little cooking oil or salt and run one or two rinses without detergent.

Can I keep using it with a small leak?

We don't recommend it — leaks grow and can reach electrical parts.

Dishwasher leaking? Call our dishwasher repair service — same-day visit, free diagnostics. 055 958 38 39

Appliance broken?

Contact us now — a professional technician will come to your home!

Free diagnostics included